DIY cat cosplay

In this tutorial I will show you how to make a few simple accessories that can be used for general cat cosplay or can be altered for a specific cosplay.

First cat ears!

You will need: 

Felt for the inside of the ear

Soft fabric for the outside

Paper and pen

Scissors

Two hairclips

Needle and thread

Start by drawing your cat ear shape and cut it out.

Trace the shape onto your fabric twice and cut it.

Sew along the edge as shown but leave the bottom open.

Turn it inside out and you shouldhave this.

Fold in half and sew along the open edge at the bottom, you can sew the folded end inwards as I did to give it a better shape.

From the opening it should look like this.

Sew or glue on a hairclip onto the bottom.

You can also add a ribbon to cover the seam and make it look a little cuter.

Now the cat collar choker:

You will need:

Wide velvet ribbon

Two strips of thinner ribbon long enough for you to tie

A bell

A candle

Lighter

Scissors

A needle and thread

First cut a length of velvet ribbon about a cm less than your neck measurement. Also cut a length about 4inches long. And cut another piece long enough to wrap around the neck length ribbon vertically.

Light a candle and use it to melt all of the ribbon ends this stops them from fraying.

Mark the neck length ribbon in the center. Fold the 4inch ribbon in half and sew along the edge.

Fold halfway between the fold and the edge so that the seam is moved to the middle.

Place the ribbon over the neck length ribbon so that the centers are matched.

Sew threw both centers.

Wrap the shortest piece of ribbon vertically around the center of the choker. Sew the ends closed at the back.

It should now look like a bow.

Sew the bell onto the bottom of the bow in the middle.

Take your ribbon of a smaller width and sew it on to either end of the choker, this enables you to tie it closed at the back.

This is the finished product I hope you found this post helpful, thanks for reading! ^ - ^